/testing/guestbin/swan-prep --x509 Preparing X.509 files north # # make sure that clear text does not get through north # iptables -A INPUT -i eth1 -s 192.0.2.254/32 -j LOGDROP north # # confirm with a ping north # ping -c 4 -n -I 192.0.3.254 192.0.2.254 PING 192.0.2.254 (192.0.2.254) from 192.0.3.254 : 56(84) bytes of data. --- 192.0.2.254 ping statistics --- 4 packets transmitted, 0 received, 100% packet loss, time XXXX north # ipsec setup start Redirecting to: systemctl start ipsec.service north # /testing/pluto/bin/wait-until-pluto-started north # ipsec auto --add northnet-eastnet-nat north # echo "initdone" initdone north # ipsec auto --up northnet-eastnet-nat 104 "northnet-eastnet-nat" #1: STATE_MAIN_I1: initiate 003 "northnet-eastnet-nat" #1: received Vendor ID payload [Dead Peer Detection] 003 "northnet-eastnet-nat" #1: received Vendor ID payload [FRAGMENTATION] 003 "northnet-eastnet-nat" #1: received Vendor ID payload [RFC 3947] 106 "northnet-eastnet-nat" #1: STATE_MAIN_I2: sent MI2, expecting MR2 003 "northnet-eastnet-nat" #1: NAT-Traversal: Result using RFC 3947 (NAT-Traversal) sender port 500 sender port 500: I am behind NAT 108 "northnet-eastnet-nat" #1: STATE_MAIN_I3: sent MI3, expecting MR3 003 "northnet-eastnet-nat" #1: received Vendor ID payload [CAN-IKEv2] 004 "northnet-eastnet-nat" #1: STATE_MAIN_I4: ISAKMP SA established {auth=RSA_SIG cipher=aes_128 integ=sha group=MODP2048} 117 "northnet-eastnet-nat" #2: STATE_QUICK_I1: initiate 004 "northnet-eastnet-nat" #2: STATE_QUICK_I2: sent QI2, IPsec SA established tunnel mode {ESP=>0xESPESP <0xESPESP xfrm=AES_128-HMAC_SHA1 NATOA=none NATD=none DPD=none} north # ping -c 3 -I 192.0.3.254 192.0.2.254 PING 192.0.2.254 (192.0.2.254) from 192.0.3.254 : 56(84) bytes of data. 64 bytes from 192.0.2.254: icmp_seq=1 ttl=64 time=0.XXX ms 64 bytes from 192.0.2.254: icmp_seq=2 ttl=64 time=0.XXX ms 64 bytes from 192.0.2.254: icmp_seq=3 ttl=64 time=0.XXX ms --- 192.0.2.254 ping statistics --- 3 packets transmitted, 3 received, 0% packet loss, time XXXX rtt min/avg/max/mdev = 0.XXX/0.XXX/0.XXX/0.XXX ms north # echo done done north # north # grep 'Result using RFC 3947' /tmp/pluto.log "northnet-eastnet-nat" #1: NAT-Traversal: Result using RFC 3947 (NAT-Traversal) sender port 500 sender port 500: I am behind NAT north # if [ -n "`ls /tmp/core* 2>/dev/null`" ]; then echo CORE FOUND; mv /tmp/core* OUTPUT/; fi north # if [ -f /sbin/ausearch ]; then ausearch -r -m avc -ts recent ; fi